Headrests With Monitor, Removing and Installing

Headrests With Monitor, Removing And Installing

Removing

NOTE: All cable ties opened or cut during engine removal must be reinstalled at the same locations during installation.

- Remove front seat.
- Remove outer trim panel for seat frame.

Seat without folding table (where applicable)
- Remove backrest panel.

Seat with folding table (where applicable)
- Remove folding table.







- Remove hose clamps - 1 - and - 2 -.
- Remove bolt - 3 - at cable clip.







- Unclip wire connector from front bracket under seating surface (arrow).







- Cut cable ties (arrows) and pull free the electrical wire to monitor.
- Pull electrical wire to monitor through to the rear.







- Press release button (arrow) and pull off headrest upward.
- Carefully place headrest with monitor onto seating surface - electrical wire is still inside headrest guide.







- Release headrest guide with wiring using a socket insert 17 mm - item 1 -.

NOTE: Depicted in illustration with backrest cushion removed.







- Remove headrest guide together with electrical wire upward out of backrest (arrows).
- Remove cable connector from backrest through headrest guide mount.

Installing
Installation is reverse of removal, noting the following:







- Route electrical wire to monitor parallel to seat wiring harness as depicted in the illustration.
- Attach cable ties onto areas designated with arrows.

Seat without folding table (where applicable)
- Install backrest panel.

Seat with folding table (where applicable)
- Install folding table.

All:
- Install outer trim panel for seat frame.

Tightening torques

Component Nm
Cable clip for tube for monitor 2
cable to headrest mount
Hose clamp for securing to headrest 2