Lubrication System Components, Removing and Installing

Note: Always replace gaskets and seals.

1. Oil pan, lower
2. 10 Nm (89 inch lbs.)
3. Oil pan, upper
4. 10 Nm (89 inch lbs.)
5. Honeycomb baffle
6. Circlip
7. Rubber fitting
8. Strainer
9. Oil pump
^ Removing, Refer to Oil Pump, Service and Repair.
^ Replace complete assembly only
10. 25 Nm
11. Baffle
12. 35 Nm (26 ft. lbs.)
13. 25 Nm (18 ft. lbs.)
14. 10 Nm (89 inch lbs.)
15. 25 Nm (18 ft. lbs.)
16. 85 Nm (63 ft. lbs.)
^ Always replace
^ Install with locking compound AMV 188 001 02
17. Disc
18. Drive plate
^ When assembling, make sure that pin for ignition timing point is installed in drive plate
^ Length of pin measured from drive plate: 20-22 mm (approximately 13/16 inch)
19. Oil seal
^ Replacing, Refer to Crankshaft Main Bearing Seal, Service and Repair.
20. 10 Nm (89 inch lbs.)