Operation CHARM: Car repair manuals for everyone.

Intake Manifold Tuning (IMT) Valve Electrical Testing




Intake Manifold Tuning (IMT) Valve, Checking

Intake Manifold Tuning (IMT) valve, electrical testing
- Switch ignition on.

Initiate output Diagnostic Test Mode (DTM) and check actuation of intake manifold change-over valve -N156-. Refer to "Scan Tool Testing/Output Diagnostic Test Mode (DTM), (Function 03)" Testing and Inspection


Output Diagnostic Test Mode ->
Intake manifold change-over valve -N156



The valve should click (confirm by sound and touch). After one minute, the output DTM will be interrupted.

If valve does not click:
- Switch ignition off.
- Disconnect harness connector from IMT valve.







- Connect multimeter US 1119 (Fluke 83 or equivalent) and measure resistance across IMT valve terminals.
Specified value: 25 - 35 ohms

If resistance is not OK:
- Replace intake manifold IMT valve.

If resistance is OK:







- Connect VAG1527B LED voltage tester between harness connector terminal 1 and Ground, using adapter cables from VAG1594 connector test kit.
- Switch ignition on.
LED must light up.

If LED does not light up:
- Check fuse for intake manifold IMT valve in electronics box (E-box) in plenum.

If fuse is OK:
- Check wiring for open or short circuit between IMT valve harness connector terminal 1 and fuse in E-box.

If wiring (voltage supply) is OK:
- Connect VAG1598/19 test box to ECM harness connector. Refer to "Scan Tool Testing/SCan Tool Connecting and Initial Checks/VAG1598/19 Test Box, Connecting", Testing and Inspection







- Check wiring for open or short circuit between IMT valve harness connector terminal 2 and ECM/test box socket A5.

If wiring is OK:
- Replace ECM and generate new readiness code. Refer "Monitors, Trips and/or Drive Cycle (Readiness Code)/Generating, Readiness Code" Testing and Inspection
- Check intake manifold IMT valve function. Intake Manifold Tuning (IMT) Valve Function, Checking