Headlamp Igniter Module: Service and Repair

Igniter for Gas Discharge Lamps -N195-, Removing and Installation


WARNING HIGH VOLTAGE!
ALWAYS disconnect battery Ground (GND) strap before working on parts of the gas discharge headlights marked with the yellow high voltage symbol.







Removing
- Remove headlight.
- Release retaining clamps and mounting units and remove rubber seal
- Remove headlight lens -1- by removing the six retaining clamps -15-.
- Remove ball head of adjusting motor -12- adjustment axle from ball head mount.
- Remove reflector -4-. Turn adjustment screws for vertical and horizontal adjustment enough that reflector can be removed.
- Open housing cover -9- and remove connector at gas discharge lamp by turning counter clockwise.
- Remove both mounting bolts -14- and remove the igniter for gas discharge lamps -11-.

Installing
- Complete installation in reverse order of removal.
- Adjust headlights after installing.