Reading Transmissions with hydraulic control -E17-

Read Measuring Value Block (Scan Tool Function 08) For Transmissions With Hydraulic Control -E17-


WARNING!
To avoid accidents during measuring and test drives, observe safety precautions.


Procedure
- Connect VAS5051 tester or V.A.G 1551 Scan Tool (ST) and select Transmission Control Module (TCM) using "address word" 02. Ignition must remain switched on. Scan Tool Connecting and Initial Checks

Indicated on display


Rapid data transfer HELP
Select function XX


- Press PRINT button to turn on ST printer. Indicator lamp in button must light up.
- Press buttons -0- and -8- to select "Read Measuring Value Block" and press -Q- button to confirm input.

When indicated on display:


Read measuring value block Q
Enter display group number XXX


- Enter desired display group number, display group overview.
- Press Q button to confirm input.

Indicated on display (example) for display group 001:


Read measuring value block 1 ->
1 2 3 4


NOTE:
- Explanation of values in the individual display fields Test table. Evaluating Measured Value Blocks -E17-
- Display can be printed out when printer is switched on.
- To switch to a different display group, proceed as follows:







Indicated on display (function selection):


Rapid data transfer HELP
Select function XX


Overview of selectable display group numbers for transmission with hydraulic control -E17-






















NOTE:
- When the printer is switched on, the contents of the display will be printed out on the scan tool log.
- If specified values are not obtained in all display fields:


- Press -> button.

Indicated on display


Rapid data transfer HELP
Select function XX