Read Measuring Value Block (Function 08)

Read Measuring Value Block (Function 08)

Test requirements:
- Coolant Temperature at least 80 °C.
- Electrical consumers switched off (radiator fan must NOT run during test).
- A/C switched off.

Test sequence
- Connect VAS5051 tester or VAG1551 scan tool and select control module for engine electronics using "address word" 01. Engine must run at idle. [1][2]Scan Tool Connecting and Initial Checks

When indicated on display

Rapid data transfer HELP
Select function XX

- Press buttons -0- and -8- to select "Read Measuring Value Block" and press -Q- button to confirm input.

When indicated on display

Read measuring value block Q
Enter display group number XXX

- Enter desired three digit display group number and confirm by pressing -Q- button.


NOTE: Which display group should be chosen depends on current function and component tests.


Indicated on display for display group 000


Read Measuring Value Block 0 ->
1 2 3 4 5 6 7 8 9 10


Indicated on display (example) for display group 001


Read Measuring Value Block 1 ->
1 2 3 4


NOTE:
- Display can be pointed out on the paper roll when printer is switched on.
- To switch to a different display group, proceed as follows: