Ultrasonic Interior Monitoring On Board Diagnostic, Initiating

Ultrasonic Interior Monitoring On Board Diagnostic (OBD), Initiating

Requirements
- Fuse OK according to wiring diagram
- VAG 1551 Scan Tool (ST) connected.
- Anti-theft system not armed

NOTE:
- If the display remains blank, check VAG 1551 voltage supply according to wiring diagram.
- The scan tool HELP button can provide additional operating instructions.
- The -> button is used to advance through the program sequence.
- If an incorrect entry is made, press the -C- button to escape.

- Switch ignition on.
- Switch printer on by pressing PRINT button (indicator lamp in button lights up).
- Press button -1 - to select "Rapid data transfer" operating mode 1.

Indicated on display

Rapid data transfer HELP
Insert address word XX

Address word for interior monitoring: 45

- Press buttons -4- and -5- to insert "Int. Monitoring" address word 45.

Indicated on display

Rapid data transfer Q
45 - Int. Monitoring

- Press -Q- button to confirm input.

Indicated on display after about 5 seconds

4B0951173 Int. Monitoring D00 ->
Coding 00101 WSC 00812

- Press -> button.

NOTE: A list of available functions is printed out when the HELP button is pressed.

On Board Diagnostic (OBD) functions
The following functions are possible:
01 - Check Control Module Versions.
02 - Check DTC Memory.
03 - Output Diagnostic Test Mode.
05 - Erase DTC Memory.
06 - End Output.
07 - Code Control Module.
08 - Read Measuring Value Block.
10 - Adaptation.