6 SPD Manual 01E AWD

Speedometer sender -G22- and drive wheel for speedometer sender, removing and installing
^ Transmission installed





Removing and installing speedometer sender -G22

- Pull connector off sender -B-.
- Press sender retainer down, turn and pull out sender.
- Replace O-ring -A-.

Removing and installing drive wheel for speedometer sender -G22
Removing:
- Detach drive axle from left drive flange -B-.





- Unscrew bolt -A-. Secure drive flange with a drift to prevent it turning.
- Remove drive flange and seal -C-.





- Using a screwdriver, pry out drive wheel for speedometer sender -D- on alternate sides at the follower lugs (arrows).

Installing:
- Install drive wheel for speedometer sender so that follower lugs (arrows) face toward seal.

Note: Fit the drive wheel carefully onto the differential, making sure that it is kept straight. Do not use force; the drive wheel can break easily.

- Follower lugs engage in differential housing grooves.
- Replace seal for drive flange and install drive flange, Refer to Seals and Gaskets, Differential, Service and Repair
- Top up oil in transmission and check oil level.