Read Measuring Value Block (Scan Tool Function 08)

Carrying out "Read Measuring Value Block" function 08

Indicated on display


Rapid data transfer HELP
Select function XX


- Press buttons -0- and -8- to select "Read Measuring Value Block" function 08.

Indicated on display


Rapid data transfer Q
08 - Read Measuring Value Block


- Press -Q- button to confirm input.

Indicated on display


Read Measuring Value Block HELP
Input display group number XXX


- Input display group number (from table below ) and press -Q- button to confirm input.
- The measuring value block which has been selected will appear in the standard format.

Summary Of Display Groups:

Display group 001:

Display Group 002:

Display Group 003:

Display Group 004:

Display Group 005:

Display Group 006:

NOTE: The VAG1552 mobile Scan Tool (ST) can be used instead of the VAG1551. However the VAG1552 scan tool does not have printing capabilities.


Test conditions
- Battery voltage at least 11 V
- Ground (GND) connections on engine and transmission OK
- Fuse OK







- Unclip cover for Data Link Connector (DLC), located under driver's side knee bar, behind steering wheel (left-side).
- Connect VAG1551 or VAG1552 Scan Tool (ST) with VAG1551/3 adapter cable to DLC.

Indicated on display 1)


V.A.G - ON BOARD DIAGNOSTIC HELP
1 - Rapid data transfer
2 - Blink code output


1) Operating modes 1 and 2 are displayed alternately


NOTE: If the display remains blank:
See Scan Tool operating instructions


- Switch ignition on.
- Switch on printer by pressing PRINT button (indicator lamp in button lights up).
- Press button -1- to select "Rapid data transfer" operating mode 1.

Indicated on display


Rapid data transfer HELP
Select function XX


NOTE: In "Rapid data transfer" operating mode 1 the "Automatic Test Sequence" function 00 can be carried out. This checks the Diagnostic Trouble Code (DTC) memory of all the vehicle control modules (that have OBD capabilities) automatically.