Tie-Down, Removing and Installing

- Remove bolts (2x) for each tie-down.
- Tightening torque: 4.5 Nm (40 in. lb)
- Remove trunk mat.
- Remove side trim.
- Remove trunk mat backing and brackets for front and rear tie-downs.







Installation is the reverse of removal
Tightening torques for front brackets:
- Phillips-head screw (2x with front-wheel drive; 4x with all wheel drive): 6 Nm (53 in. lb)
- Hex bolt (1x-only for front wheel drive): 30 Nm (22 ft lb)







Tightening torques for rear brackets:
- Bolt in floor: 23 Nm (17 ft lb)
- Bolt in rear panel: 10 Nm (7 ft lb)