Basic Setting

Basic Setting
Display group 2 (002): Actuation of Electronic Stability Program (ESP) hydraulic pump -V156-
Actuation of the ESP hydraulic pump -V156- is used to bleed the hydraulic system.
- Connect VAG1551 or VAG1552 Scan Tool (ST).





Indicated on display 1)
1) Operating modes 1 and 2 are displayed alternately
- Switch ignition on.
- Press "PRINT" button to switch printer on; indicator lamp in button comes on.
- Press button -1- to select "Rapid data transfer" operating mode 1.
- Press buttons -0- and -3- to insert "Brake Electronics" address word 03.
- Press -> button.





Indicated on display
- Press button -1- twice to select "Login procedure" function 11.





Indicated on display
- Enter code number 40168 and press -Q- button to confirm input.





Indicated on display
- Press buttons -0- and -4- to select "Basic Setting" function 04.





Indicated on display
- Press -Q- button to confirm input.





Indicated on display
The left-front bleeder screw should be open when actuating the hydraulic pump.
- Press buttons -0-, -0- and -2- to input display group number 2 (002) and press -Q- button to confirm input.

The Electronic Stability Program (ESP) hydraulic pump -V156- is actuated for 10 seconds.





Indicated on display
- Close bleeder screw.
- Press -> button to advance through program sequence.





Indicated on display refer to ABS/EDL/ASR On Board Diagnostic (OBD)
- The remaining installation procedures are the reverse of removal.