Valve Body, A/T

1- Drain plug - 40 Nm (30 ft lb)
- 5 mm hex socket
2- Seal
- Always replace
3- Bolt - 10 Nm (7 ft lb)
- Tighten bolts for oil pan diagonally in several stages
5- Gasket
- Always replace
7- Bolt - 8 Nm (70 inch lb)
- For attaching valve body: 1 bolt M6 x 30, 16 bolts M6 x 60
8- Valve body
9- Bolt - 8 Nm (70 inch lb)
- Item 7
10- Bracket for wiring harness
- Insert wiring harness
- Attached with bolts for valve body
11- Bolt - 6 Nm (53 inch lb)
- Always replace
12- Transmission Vehicle Speed Sensor -G38-
13- Inner oil line
- Always replace after removing
14- O-ring
- Always replace
- Coat with petroleum jelly
15- Spacer sleeve
- Height: 8 mm
16- Speedometer Vehicle Speed Sensor-G22-
17- O-ring
- Always replace
- Coat with special grease
18- Multi-Function Transmission Range Switch -F125-
19- Bolt - 8 Nm (70 inch lb)
20- O-ring
- Always replace
- Coat with petroleum jelly
21- Locking clasp
- For wiring harness connector
- Ensure complete engagement when installing
22- Wiring harness
- Transmission Fluid Temperature Sensor -G93- integrated in wiring harness
- Release from bracket for wiring harness -item 10-
- Location of wiring harness connector: flat point of rear shoulder faces down, the lugs on the shoulder are horizontal
23- Bolt - 6 Nm (53 inch lb)
24- Transmission Input Speed Sensor -G182-
25- Spacer sleeve
- Height: 20 mm
26- Screw - 6 Nm (53 inch lb)
27- Bracket for pressure regulator
28- Solenoid Valve 4 -N91-
- With O-ring
- Apply a thin coat of petroleum jelly to O-ring before installing
29- Solenoid Valve 3 -N90-
- Without O-ring
30- Solenoid Valve 2 -N89-
- Without O-ring
- To replace, remove and install oil pan.
31- Screw - 6 Nm (53 inch lb)
32- Bracket for solenoid valves
33- Solenoid Valve 6 -N93-
- With O-ring
- Apply a thin coat of petroleum jelly to O-ring for installing
- To replace, remove and install oil pan.
34- Solenoid Valve 7 -N94-
- With O-ring
- Apply a thin coat of petroleum jelly to O-ring before installing
- To replace, remove and install oil pan.
35- Solenoid Valve 5 -N92-
- With O-ring
- Apply a thin coat of petroleum jelly to O-ring before installing
- To replace, remove and install oil pan.
36- Solenoid Valve 1 -N88-
- Without O-ring
- To replace, remove and install oil pan, and unbolt guide plate for park lock mechanism.
- When installing, do not tighten bolts for guide plate (23 Nm) when selector lever is in position "P"
37- Bolt - 6 Nm (53 inch lb)
38- Magnet
- 4 magnets in the beads of oil pan
- Clean
- Ensure that magnet is making contact with the oil pan over its full surface
39- O-ring
- Always replace
40- ATF filler plug - 80 Nm (59 ft lb)
- 17 mm hex socket