Stabilizer Bar: Service and Repair

Stabilizer bar, removing and installing
Removing
- Remove noise insulation panel.





- Remove nuts -1-.
- Remove connecting links from stabilizer bar.
- Remove nuts -2-.

Installing





- Install bushings and stabilizer bar.
- Do not apply grease
- Arrows on connecting links point in direction of travel
- If replacing stabilizer bar, check which suspension version vehicle is equipped with.
Tightening torques:
- Connecting link to stabilizer bar: 100 Nm (74 ft. lbs.) (always use new ribbed nuts)
- Nuts -2-: 25 Nm (18 ft. lbs.) (always replace)