Flex Plate: Service and Repair

Driveplate, removing and installing, installation dimensions

Driveplate

^ Hold crankshaft in position using 3242 crankshaft holder, Refer to Timing Belt, Service and Repair
^ Mark hole pattern of driveplate, shim -1and washer-2- to crankshaft.
^ Mark positions of shim -1- and washer -2- (behind driveplate).





^ Install driveplate with washer -2- (Part No. 035 105 303 A) and shim -1- 3.0 mm (Part No. 054 105 301 ) or 4.0 mm (Part No. 054 1 05 202).

CAUTION! Part numbers are listed here for reference only. Always check with your Parts Supplier for the latest information

Notes:
^ Short engines and exchange engines are supplied without a bushing in the crankshaft. Always install a new bushing before installing the driveplate.
^ Remove bushing using 2111 Kukko puller and 21/2 Kukko support.
^ Always replace driveplate mounting bolts.





Tightening Torques





^ Measure distance -a- at three places and calculate average.
Distance-a-: approximately 12.3 mm.
^ If necessary, install different shim.

Note: Before installing the engine, make sure the engine to transmission centering sleeves are installed in the engine flange.