E - Box In Plenum Chamber, Removing and Installing

Removing







- Remove plenum chamber cover bolts (arrows) and remove cover.
- Remove Engine Control Module (ECM) and auxiliary fuse/relay panel.
- Disconnect electrical connectors.
- Pull engine wiring harness out together with grommet from E-box.







- Remove two nuts -A-.
Tightening torque: 2 Nm (18 in. lb)
- Lift up E-box at rear and pull out of mounting -B-.

Installing
- When installing gasket -C-, make sure that opening in body is not covered.
- Install in reverse order of removal.