Recaro Seat Pan, Cable Routing
Recaro Seat
Recaro seat pan, cable routing
Connector station view
NOTE: In the illustration the view is shown from below, in the magnified area the view is shown from the front.
The right seat is depicted in the illustration, the left seat is a mirror image.
1 - Red, 6-pin harness connector
- Socket 1; electric. belt buckle; black.
- Socket 2; electric. belt buckle; black.
- Socket 3; voltage supply (+); red.
- Socket 4; voltage supply (-); brown.
2 - Harness connector to length adjustment motor
3 - Green, 6-pin harness connector
- Socket 1; NTC (-); brown/ white.
- Socket 2; NTC (+); black/white.
- Socket 3; heater (-); brown.
- Socket 4; heater (+); black/ yellow.
4 - Yellow, 4-pin harness connector, side airbag
- Socket 1; ignition circuit (+); black.
- Socket 2; ignition circuit (-); blue.
- Socket 3; side airbag Ground (GND); brown
5 - Cable to length adjustment motor
6 - Cable ties
7 - Side airbag cable
8 - Main wiring set
Cable routing at height adjustment motor from above
NOTE: For the sake of illustration, the seat is depicted with cushion removed in the illustrations.
The right seat is depicted in the illustration, the left seat is a mirror image.
1 - Harness connector for backrest motor and heater (seat/backrest)
2 - Harness connector to lumbar support motor
3 - Harness connector between seat and backrest heater.
4 - Cable to end switch-top
5 - Cable to switch module
6 - Motor for seat height adjustment
7 - Harness connector for seat height adjustment motor
8 - Cable for seat height adjustment motor
9 - Cable ties
10 - End switch-top
- On seat frame- outside
Cable to end switch-top
1 - Cable ties
2 - End switch-top
On seat frame-outside
Cable routing at height adjustment motor from below
1 - Harness connector for backrest motor and heater (seat/backrest)
2 - Harness connector to lumbar support motor
3 - Harness connector between seat and backrest heater.
4 - Main wiring set
5 - Cable to side airbag
6 - Cable to backrest
7 - Relay 1 and 2 for seat height adjustment
8 - Cable ties
Cable routing, front right
1 - Main wiring set
2 - Cable to belt buckle (if installed)
3 - End switch- bottom
- On seat frame-inside
4 - Cable ties
5 - Harness connector for backrest motor and heater (seat/backrest)
6 - Harness connector to lumbar support motor
7 - Harness connector between seat and backrest heater.
Cable to end switch-bottom
1 - End switch-bottom
On seat frame-inside
2 - Marking for retaining clip
3 - Retaining clip
4 - Cable ties (2x)
Make a loop around seat frame using a cable tie - 4 - and secure cable - 5 - using a second cable tie - 4 -.
5 - Cable to end switch- bottom
Belt buckle cable
1 - Belt buckle
2 - Belt buckle cable
3 - Retaining clips (2x)
4 - Cable ties
Seat heater harness connector to left seat bolster
1 - Seat heater harness connector to left seat bolster
2 - Retaining clip
3 - Cable to seat bolster
4 - Seat bolster
Seat heater harness connector to right seat bolster
1 - Seat heater harness connector to right seat bolster
2 - Retaining clip
3 - Cable to seat bolster
4 - Seat bolster
Seat heater-cable to seat surface extension
NOTE: Seat surface extension is depicted in a removed condition and from below.
1 - Seat heater cable-cable to seat surface extension