Transmission Wiring Harness, Removing and Installing

TRANSMISSION WIRING HARNESS, REMOVING AND INSTALLING

Removing
Removing and installing valve body. Refer to Valve Body.





- Using a small screwdriver, pry out retaining tabs on solenoid valve connectors, and pull off harness connectors -A- one after the other.
- Disengage wiring harness from retainers -B- on side of valve body.





- Turn valve body over, and disconnect connector from sensor for transmission RPM -1-.
- Remove first retaining clip (arrow -A-) and unclip harness from second retaining clip (arrow -B-).
- Disconnect connector -2- from solenoid valve 4 -N91-.

Installing
Installation is the reverse of removal.
- When installing harness, connect harness connectors onto respective solenoid valves.
- Clip wiring harness into retaining clips provided.

CAUTION: If not installed correctly, the wiring harness can be trapped when the valve body is installed.