Selector Lever
SELECTOR LEVER, DISASSEMBLING AND ASSEMBLINGRemove selector lever.
Disassembling
- Drive out mounting pin for selector lever using drift.
- Lift pull rod and slide selector gate out of selector lever together with Tiptronic spring mechanism.
- Release coil spring, then remove pull rod and coil spring from selector lever.
Assembling
- Place coil spring -B- onto pull rod -A-.
- Insert pull rod and coil spring in selector lever.
Installation position: rounded corner (arrow) and sharp edge point in direction of travel.
- Check that pull rod slides freely on two guides -C- on selector lever.
- Lift pull rod -D- and slide selector gate -B- with Tiptronic spring into selector lever -A-.
- Drive in mounting pin -C- using drift.
- To secure pin, make two new punch marks (arrows) at 90° to existing ones.
The mounting pin must not have more than 4 punch marks.
- Install selector lever.