Evaporative Emissions System: Service and Repair

EVAP Canister/tank Leak Diagnostic System, Servicing - FWD & AWD

WARNING: Fire hazard. DO NOT smoke or work near heaters of have anything in the area that can ignite fuel.







1 Nut - 10 Nm (7 ft lb)
2 Cover
- For EVAP canister
3 Stud bolt - 15 Nm (11 ft lb)
4 Sealing part
5 Vent line
- To Evaporative Emission EVAP Canister Purge Regulator Valve -N80
6 Vent line
- From Gravity valve at fuel tank
7 Vacuum line
- To diagnostic Leak Detection Pump (LDP) -V144-
8 Cable tie
- To fasten vacuum line at bracket of LDP pump
9 Leak Detection Pump (LDP) -V144-
- Installation position: In left rear wheelhousing below wheelhousing liner
10 3-pin electrical harness connector
- Black
11 Connecting hose
- Diagnostic pump/EVAP canister
- Pressure side
- Press release button on diagnostic pump to disconnect
12 10 Nm (7 ft lb)
13 Air filter
- For Leak Detection Pump (LDP) -V144-
- No service requirements
14 Sealing part
15 Cable tie
- To fasten connecting hose in wheelhousing
16 EVAP canister
- Installation position: In lower spare wheel molding