Removing and Installing

Removing
- Remove lower section of A-pillar trim (right-side) and sill moulding at right-front door.
- Detach carpeting from inside of sill (right-side) below front door, and raise carpeting approx. 20 cm (8 inch).
- Unclip box at -A- by pulling it upward.
- Unclip box at -B- as shown.





- Unclip TCM from box (arrows).
- Release catch on multi-pin connector and disconnect connector from TCM refer to Fig. 3.





Installing
Installation is the reverse of removal, with the following additional steps:
- Check that clip -1- is properly secured.
- Switch ignition off and wait approx. 30 seconds.





- Release connector by pressing catch in direction of arrow.

Installation is the reverse of removal.