Removing and Installing Pump For Central Locking System

Removing And Installing Pump For Central Locking System







NOTE: The pump for central locking is located in the trunk at left behind trunk trim.


- Remove rear lid trim at left-rear.
- Bend tabs (arrow) down and remove pump for central locking -3- toward rear out of bracket -7-.
- Open noise insulation components -1- and -4- and remove pump.
- Remove vacuum line -2- at pump.
- To disconnect bracket -7-, remove bolts -5-.


NOTE: After installing the pump for central locking, tabs (arrow) must always be bent up again.