Right Cylinder Head, Removing

Note:
- Secure all hose connections with correct hose clips (same as original equipment) Parts catalog
- Replace all cable ties which are opened or cut during removal in the same position when installing.
- Replace cylinder Dead bolts.
- Always replace seals, gaskets, self-locking nuts and bolts with specified tightening instructions.
- When installing a new cylinder head or cylinder head gasket, drain all old coolant and refill with new coolant.

CAUTION! Always dispose of old coolant properly.

- Drain coolant
- Remove toothed belt guard.





- Disconnect connector -1- from Camshaft Position (CMP) sensor.
- Disconnect connector -2-.
- Disconnect connector-3-.
- Remove toothed belt from camshafts
- Remove idler wheel -1-.





- Remove toothed belt cover -arrows-.





- Disconnect connectors -1- from ignition coils.
- Remove bracket -2-.
- Remove ignition coils -3-.
- Disconnect crankcase breather hose.
- Remove cylinder head cover.





- Remove coolant line -arrows-.
- Remove left exhaust pipe with catalytic converter.





- Disconnect connector -1-.
- Disconnect hose -2-.
- Remove bracket -3-.
- Disconnect connector -4-.
- Disconnect ground cable -5- at cylinder head.
- Remove bolts -6-.
- Disconnect hose -7- from combination valve.
- Remove bolts -8-.
- Disconnect connector -9-.
- Remove coolant line.





- Loosen cylinder head bolt in numerical sequence.
- Remove cylinder head and place on soft surface.