Oil Seal For Left Camshaft Position (CMP) Sensor

Special tools and equipment:





- Special tool 2085





- Installation tool 3241

Removing





- Disconnect connectors from ignition coils -arrows- and move harness aside.
- Disconnect connector from Camshaft Position (CMP) sensor.
- Remove CMP sensor housing (10 Nm / 7ft. lbs.).
- Remove CMP rotor (23 Nm / 17 ft. lbs.) and carefully lever off rotor with screwdriver.





- Screw in bolt from oil seal extractor 2085/1.





- Remove seal with seal extractor 2085 and bolt 2085/1

Installing
- Clean contact and sealing surfaces.
- Do not apply oil to sealing lip or outer circumference of seal before installing.
- Install guide sleeve (from tool set 3241) onto camshaft.





- Press in seal until flush using press sleeve 3241/1 and bolt 3241/3.
- Install Camshaft Position (CMP) sensor rotor.
- Install CMP sensor housing.
- Connect connector for CMP sensor.

Tightening Torques (Part 13 Of 18):

Tightening Torques (Part 14 Of 18):

Tightening torques

- Unplug connector from Hall sender.