Oil Seal For Right Camshaft Position (CMP) Sensor

Special tools and equipment:





- Special tool 2085





- Installation tool 3241

Removing





- Remove cover -1-.
- Remove air intake hose for air cleaner -2- .





- Counter-hold viscous fan pulley with pin wrench 3212 and tighten fan using opened wrench 3312 and torque wrench (fan has left-hand thread).





- Remove cover -arrows-.
- Remove right toothed belt cover.
- Disconnect connector for Camshaft Position (CMP) sensor.





- Remove bolts -1-.
- Loosen bolt -2-.
- Pull toothed belt cover toward front and remove CMP housing.





- Install bolt from seal extractor 2085/1.





- Remove seal with seal extractor 2085 and bolt 2085/1.

Installing
- Clean running and sealing surfaces.
- Do not oil sealing lip or outside seal ring before installing.
- Install installation tool 3241 on camshaft.





- Install seal with installation tool 3241/1 and bolt 2085/1 until flush.
- Install Camshaft Position (CMP) sensor.
- Connect connector for CMP sensor.

Tightening Torques (Part 12 Of 18):

Tightening torques