Switch Unit Circuit Board, Removing and Installing

Switch Unit Circuit Board, Removing And Installing







WARNING: Before starting work on seats, connect VAS 5094 airbag adapter.

CAUTION: Only the switch circuit board can be removed. The switches in the side seat trim cannot be replaced separately.

NOTE: The switch unit circuit board is installed in the side seat trim on door sill side.

1 - Plastic cover
2 - Bolts (4x)







3 - Switch unit circuit board with wiring harness
Removing:
- Move seat to bottom-most position.
- Remove seat.
- Remove door sill side seat trim.
- Cut all tie wraps on wiring harness using diagonal cutter.
- Disconnect all wiring harness connectors to circuit board.
- Remove bolts - 2 - (4x) at plastic cover - 1 - located above circuit board - 3 -.
- Remove plastic cover - 1 -.
- Remove bolt - 4 -.
- Carefully remove circuit board.
Installing:
- Carefully install circuit board so circuit board contacts seat correctly on contacts for switch located in side seat trim.
4 - Bolt (1x)