Rear Belt Adjuster - Interior Trim, Removing and Installing

Rear Belt Adjuster, Removing And Installing

Removing

NOTE: It is not necessary to remove the rear shelf when removing the rear belt adjuster.







- Undo lower anchoring point of rear three-point seat belt.
Tightening torque: 50 Nm (37 ft.lb)
- Unclip belt guide cover - 3 -.
- Detach belt adjuster cover - 2 - at left and right of retaining tab - 7 -.
- Swing belt adjuster - 4 - with belt webbing upward.







- Use screwdriver to press retaining tab - 1 - (2x) inward while simultaneously pulling up on belt adjuster - 2 -.
- Pull belt webbing through belt adjuster - 2 -.

Installing







- Make sure retaining tabs - 1 - (2x) fully engage.
- Make sure rear lug engages in notch - 6 -.
Adjustment locking device - 5 - must point toward center of vehicle.