Door

Door, Adjusting

NOTE: Panel gaps can be checked using special tool 3371.







Fig. 1 Panel gaps

Dimension A = 4 mm + 1 mm
Dimension B = 4 mm + 1 mm
Dimension C = 3.5 to 4.5 mm
Dimension D = 5 mm ± 1.5 mm
Dimension E = 3.5 mm + 1 mm







Fig. 2 Adjusting door at striker plate

- Loosen bolts - 2 -.
- Move striker plate - 1 - until door shell is flush with contour of body.
- Tighten bolts.
Tightening torque: 20 Nm

NOTE: Use this adjustment only to align door inward or outward, not vertically, otherwise lock can be damaged.