Headlights, Removing and Installing

WARNING! Always disconnect the battery Ground strap before working on the electrical system.

NOTE:
- On vehicles with coded radio, obtain anti - theft code before disconnecting battery.
- When the battery is reconnected, re - activate electrical equipment (radio, clock, electric windows, engine management).
- After carrying out work that may affect the headlight settings, always re-adjust the headlights.

Removing:
- Remove bumper.
- Remove cover for engine compartment, right or left.
- Remove cover for headlight, left or right (press locking pin at the relevant spring clip, but not all the way through, and remove spring clip upward).





- Unscrews 3 combi bolt -1- (tightening torque: 6 Nm).
- The headlight is just a press fit in retainer - 3-. Retainer -3- is secured with combi bolt -2- (tightening torque: 6 Nm).
- Pivot headlight outward and pull it out of retainer -3-.
- Unplug multi - pin connectors on headlight and take headlight out of body from front of vehicle.

Installing





Installation is carried out in the reverse order of removal.
- After installation, the headlight must be aligned flush with the contours of the bumper and body.
- The adjuster screw provided for this purpose (dotted circle) is accessible from the front through the radiator grille.
- Using a suitable tool -5-,loosen securing bolt -4-.
- Using a Phillips - head screwdriver -6- ,turn adjuster screw -3- so that headlight lens -1- is flush with bumper -2-.
- Tighten securing bolt -4- again.
- Adjust headlights after installing.