Engine Mounts, Adjusting

Engine mounts, adjusting

- Unbolt hydraulic fluid reservoir above right-hand engine mount and pull to one side.






- Distance -a- between engine console -1- and support arm -2- of right-hand engine mount should be about 13 mm. It should be possible to insert a 12 mm flat iron bar without difficulty (e.g. special tool 2011).

If the gap is too narrow or too wide, proceed as follows:






- Remove air hose -4- from mass air flow sensor.
- Disconnect electrical connectors for mass air flow sensor -1-.
- Remove bolts -2- and -3-, then remove air cleaner housing.






- Set up engine support 10-222A on the two wing panel flanges and set up with supports 10-222A/1 and two spindles.
- Bolt retainer 3180 to the right-hand lifting eye and engage on hook at end of right-hand spindle.
- Engage hook at end of left-hand spindle in left-hand lifting eye.
- Raise the engine slightly, taking up the weight evenly on both spindles.






- Slacken bolts -b- on left and right-hand support arms by about two turns each.
- Insert an iron bar between engine console and support arm, then move engine until gap -a- measures 13 mm.
- Tighten (by hand) all four bolts -b- on left and right-hand support arms.
- Then tighten all four bolts to 85 Nm.

Note: Note the following important points when installing

Tightening torques.

- Routing of ribbed belt on vehicles without air conditioner. Service and Repair
- Routing of ribbed belt on vehicles with air conditioner. Service and Repair

Note: Pumps supplied as spare parts are not filled with fluid. For this reason, the pump must be filled with G 002 000 hydraulic fluid and rotated by hand before installation. The pump may otherwise be damaged or noisy during operation.
There should not be any paint on the contact surfaces or threads on either side of the vane pump.
Do not reuse drained hydraulic oil.
Replace O-rings.





- Install spring clip and suction hose as shown in the illustration.
- Longitudinal mark -A- on suction hose must line up with seam on pump.
- Install spring clip no further than transverse mark -B-.