Bearing For Longitudinal Control Arm

Removing and installing

Special tools and equipment





- 3301 bearing
- 3346 Support arm bearing tool
- 3348/1 Front and rear bearing tool
- T 10030/2 Pipe

Removing
- First remove spring





- Remove bracket - 1 - for brake line from longitudinal control arm.





- Unclip brake line from bracket (arrows).
- Mark installation position of mounting bracket at mount.





- Remove mounting bracket from mount.





- Mark installation position of mounting bracket at longitudinal control arm (i.e. using felt - tip pen).
- Note arrows and dotted line
1 - Longitudinal control arm
2 - Bracket

Removing bonded rubber bushing from longitudinal control arm





- Attach tools as shown in illustration
- Remove bonded rubber bushing by turning support arm bearing tool.

Installing bonded rubber bushing





- Attach tools as shown in illustration
- Install bonded rubber bushing by turning support arm bearing tool.

Installing longitudinal control arm
Remainder of installation is the reverse of removal.
If installation position of mounting bracket was not marked at longitudinal control arm,