Part II - Oil Filter Bracket Components

Part II - Oil filter bracket components






1. Screw plug - 40 Nm

2. Sealing ring
Always replace

3. Spring
For pressure relief valve, approximately 4 bar

4. Piston
For pressure relief valve, approximately 4 bar

5. Gasket
Always replace

6. Oil retention valve
Tighten to 8 Nm
Built into oil filter bracket

7. O-ring
Always replace
Slide on until flush with collar on pipe -Item 9-

8. Locking clip

9. Pipe
For crankcase breather

10. 20 Nm
Install with locking fluid D 000 600 A2

11. Bottom coolant pipe
12. Screw plug - 15 Nm

13. Sealing ring
If seal is leaking, cut open and replace

14. Oil supply pipe
To turbocharger

15. Banjo bolt - 30 Nm

16. Seals
Always replace

17. Oil pressure switch F -1-, 1.4 bar 25 Nm
Black insulation

18. Sealing ring
If seal is leaking, cut open and replace

19. 15 Nm + 1/4 turn(90°C) further
Always replace

20. Gasket
Always replace
Engage in projections on oil cooler

21. Oil filter
Observe change intervals
Observe installation instructions on oil filter
Tighten to 20 Nm

22. 25 Nm

23. Oil cooler
Ensure clearance to adjacent components
Coolant hose connection diagram

24. Oil filter bracket
With pressure relief valve, approximately 4 bar