Exhaust system components, removing and installing
Exhaust system components, removing and installing, vehicles with front wheel drive
1. 25 Nm
2. Mounting
3. 25 Nm
4. Mounting
5. 25 Nm
6. 25 Nm
^ Replace
7. 30 Nm
^ Always replace
8. Gasket
^ Always replace
9. Turbocharger
10. Catalytic converter
^ Protect from damage by impact
11. Oxygen sensor - 55 Nm
^ Upstream of catalytic converter
^ Grease only the threads with high temperature lubricant G 052112 A3. The lubricant must not get into the slots on the sensor body.
12. Oxygen sensor - 55 Nm
^ Downstream of catalytic converter
^ Grease only the threads with high temperature lubricant G 052112 A3. The lubricant must not get into the slots on the sensor body.
13. Gasket
^ Always replace
14. Front exhaust pipe
^ With flexible connection (de coupling element)
^ Do not bend flexible connection more than 10° otherwise it can be damaged.
^ Align exhaust system so it is free of stress before tightening clamp.
15. Mounting
^ Individual parts of mounting for manual gearbox Refer to, Fig. 3.
^ Individual parts of mounting for automatic 5 speed gearbox Refer to, Fig. 4
16. Front clamp
^ Align exhaust system so it is free of stress before tightening clamp.
^ Installation position Refer to, Fig. 1
^ Tighten bolted connections evenly.
17. 40 Nm
18. Mounting
19. 25 Nm
20. Rear muffler
^ Rear and center mufflers are one unit as original equipment. In cases of repair replace individually
^ Align exhaust system so it is free of stress before tightening clamp.
21. Rear clamp
^ For separate replacement of center and rear mufflers
^ Align exhaust system so it is free of stress before tightening clamp.
^ Installation position Refer to, Fig. 2
^ Tighten bolted connections evenly.
22. 40 Nm
23. 25 Nm
24. Mounting
25. Center muffler
^ Center and rear mufflers are one unit as original equipment. In cases of repair replace individually
^ Align exhaust system so it is free of stress before tightening clamp.
Fig. 1 Installation position of front clamp
^ Align clamps so that ends of bolts do not protrude over lower edge of clamp.
- Bolted connection facing to the left
Fig. 2 Installation position of rear clamp
^ Install clamp in horizontal position.
- Bolted connection facing to the left