Drive Belt: Adjustments

Ribbed Drive Belt For A/C Compressor (4-Cyl. Engine), Removing and Installing

Removing:


NOTE: Removing and installing ribbed belt (6-cylinder engine).


- Detach complete front bumper/grille assembly (service position).


CAUTION!
Mark running direction of ribbed belt before removing (if belt is installed in the opposite running direction, belt damage may result).







- Loosen both hex socket bolts -A-.

Installing:
- Position ribbed belt over drive pulleys and check for correct position.
- Using torque wrench (See illustration), tension ribbed belt via tensioner pulley in direction of arrow to 25 Nm (18 ft lb).
- Tighten both hex socket bolts -A- to 20 Nm (15 ft lb).