Electronics Box (E-Box) In Plenum Chamber, Replacing

CAUTION!
Disconnect the battery Ground (GND) strap before working on the electrical system.

NOTES:
- Before disconnecting the battery, determine the correct coding for the anti-theft radio.
- After reconnecting the battery, check and activate the vehicle's electrical equipment (radio, clock, comfort and convenience features, etc.) as outlined in the Owner's Manual.





- Remove mounting bolts (arrows) and pull off cover.
- When installing, press cover on by hand and tighten mounting boils in diagonal sequence. Tightening torque: 4 Nm (35 in. lb) (also see information on cover).
- Remove engine control module and, if necessary, remove auxiliary relay panel/auxiliary fuse panel. Auxiliary Relay Panel/Auxiliary Fuse Panel, Replacing
- Disconnect harness connector at connector station.
- Pull out engine wiring harness together with rubber grommet from opening in electronics box.





- Remove both nuts -A- (4 Nm or 35 in. lb).
- Lift electronics box off studs at rear and pull out of mount-B-.

Note the following when installing:

- Install in reverse order of removal.
- Always replace seal -C-: seal must not overlap opening in body and edge of sheet metal.