Connector Locations

5 Speed Automatic 01V

88-pin connector for Transmission Control Module (TCM) -J217- (sockets on VAG1598/20)

1 - Solenoid valve 5 -N92-
2 - Shift lock solenoid -N110-
3 - Vacant
4 - Solenoid valve 7 -N94-
5 - Solenoid valve 4 -N91-
6 - Ground (GND) for power consumers, term. 31
7 - Vacant
8 - Multi-function TR switch -F125-, L2
9 - Multi-function TR switch -F125-, L4 supply voltage for cruise control system
10 - Brake light switch -F- (not for E-gas and V6-TDI)
11 - Vacant
12 - Vacant
13 - Tiptronic recognition
14 - Transmission VSS -G38-
15 - Transmission VSS -G38- (shielding)
16 - Sensor for transmission RPM -G182-
17 - Signal for malfunction monitor (OBD II - request) 1) 2)
18 - Kick-down switch -F8- (not for E-gas and V6-TDI)
19 - Control input to transmission from ABS control module
20 - Engine intervention (via ignition timing) 1)
21 - ATF temperature sensor -G93-
22 - ATF temperature sensor -G93-
23 - Sensor for transmission RPM -G182- (shielding)
24 - Vacant
25 - Selector lever display (not for Highline combi)
26 - Supply voltage (terminal 30) with or without fuses depending on model See wiring diagram
27 - Kick-down for air conditioning 1)
28 - Ground (GND) for electronics (terminal 31) 4)
29 - Solenoid valve 6 -N93-
30 - Solenoid valve 1 -N88-
31 - Vacant
32 - Solenoid valve 3 -N90-
33 - Solenoid valve 2 -N89-
34 - Ground (GND) for power consumers (terminal 31)
35 - Fuel consumption signal (engine torque, actual) 1)
36 - Multi-function TR switch -F125-, L1
37 - Multi-function TR switch -F125-, L3
38 - Vacant
39 - Vacant
40 - Engine speed (RPM) signal 1)
41 - Throttle position value (load signal) 1)
42 - Transmission VSS -G38-
43 - Vacant
44 - Sensor for transmission RPM -G182-
45 - Vacant
46 - Tiptronic upshift switch
47 - Tiptronic downshift switch
48 - Vacant
49 - Vacant
50 - Vacant
51 - Upshift/downshift signal (for engine torque reduction)
52 - Supply voltage for solenoid valves
53 - Supply voltage for solenoid valves
54 - Supply voltage (terminal 15)
55 - Supply voltage (terminal 15)
56 - Vacant
Terminals 57 - 83 are vacant
84 - Vacant
85 - CAN-bus 3)
86 - CAN-bus 3)
87 - Vacant
88 - K-wire for On Board Diagnostic (OBD)

1) Only for vehicles without a CAN-bus.
2) Signal is transmitted to Transmission Control Module (TCM) via the Engine Control Module (ECM) and can only be checked in read measured value block.
3) Only for vehicles with a CAN-bus. Further information for CAN-BUS on the CAN-bus.
4) Pin 28 at the control module is vacant for vehicles with 10-pin connector of multi-function switch - F125-.