Select Cable For Shift Mechanism W/O Tiptronic Check and Adjust

5 Speed A/T 01V

Selector lever cable for shift mechanism (without Tiptronic), checking and adjusting
Checking:





- Removing retaining clip -C- for selector lever cable at lever/shift lever.
- Press selector lever cable off of lever/shift lever.
- Shift selector lever from "P" to "2".
^ Shift mechanism and selector lever cable must have freedom of movement during this, if necessary, replace selector lever cable or service shift mechanism.
- Switch selector fever to "P".
- Shift lever/shift lever to "P" (last position, shift lock solenoid must engage).
^ It must be possible to push selector lever cable onto lever/shift rod, if necessary adjust selector lever cable.

Adjusting
- Place selector lever in position "P".
- Shift lever/shift lever to "P" (last position, shift lock solenoid must engage).





- Slightly loosen mounting bolt at bracket to transmission.
^ Check freedom of stress of selector lever cable, if necessary eliminate stress.
- Tighten mounting bolt of bracket to 23 Nm.
- Check shift mechanism.