Transmission Selector Mechanism, Disassembling & Assembling: Overview

Transmission Selector Mechanism, Disassembling And Assembling

For the installation position of the complete selector mechanism in transmission, Fig. 6 Installation Position of Selector Mechanism In Trans.

Special Tools And Equipment

- VW295 Needle Bearing Drift
- VW295A Needle Bearing Drift
- VW401 Thrust Plate
- VW423 Sleeve
- VW472/2 Spacer Sleeve
- VW771 Peening Tool
- Kukko 21/4 Extractor





For the installation position of the complete selector mechanism in transmission Fig. 6 Installation Position of Selector Mechanism In Trans.

1. Gear Lock 5th And Reverse Gear
- Removing and installing, Removing and Installing Gear Lock For 5TH and Reverse Gear
2. Torx Bolt
- 10 Nm (7 Inch Lbs.)
3. O-ring
- Always replace
4. Right Stop Bolt
- 40 Nm (30 Ft. Lbs.)
5. Sealing Washer
6. Relay Shaft
7. Sealing Washer
8. Left Stop Bolt
- 40 Nm (3 Ft. Lbs.)
9. Shift Detent
10. Torx Bolt
- 25 Nm (18 Ft. Lbs.)
11. Roll Pin
12. 5th And Reverse Gear Shift Fork
- Installation position Fig. 1 Install Position 5TH/Reverse Gear Fork/Shift Rod Coupler
13. Shift Rod For 1st And 2nd Gear And For 5th And Reverse Gear
- Installation position, Fig. 1 Install Position 5TH/Reverse Gear Fork/Shift Rod Coupler
14. Ball Sleeve
- Removing and installing Fig. 2 Removing and Installing Ball Sleeve
15. Shift Fork For 1st And 2nd Gear
16. Coupling Plate
- Installation position Fig. 1 Install Position 5TH/Reverse Gear Fork/Shift Rod Coupler
17. Bushing -for 3rd And 4th Gear
- Removing Fig. 3 Removing Bushing For 3RD and 4TH Gear Shift Rod
- Installing Fig. 4 Drive In Bushing For 3RD and 4TH Gear Shift Rod
18. Ball Sleeve
- Removing and installing Fig. 2 Removing and Installing Ball Sleeve
- Pry Off Selector Rod Using Screwdriver
- press onto selector rod
19. Shift rod for 3rd and 4th gear
- Installation position Fig. 1 Install Position 5TH/Reverse Gear Fork/Shift Rod Coupler
20. Shift Fork For 3rd And 4th Gear
21. Roll pin
22. Cover
- For shift rod
23. Torx Bolt
- 20 Nm (15 Ft. Lbs.)
24. Shift rod
25. Sealing washer
- Pry out using screwdriver
- Installation position Fig. 5 Installation Position of Sealing Washer