Door Mirrors

Door Mirrors, Removing And Installing







1 - Mirror housing
- Can be removed from door without removing mirror completely
2 - Mirror adjustor
- Before removing, remove mirror from door

- To remove, pry off mirror glass, disconnect harness connectors for mirror heating, remove phillips head screws - 6 - and take mirror adjustor - 1 - out of mirror housing.

NOTE: On vehicles with seat memory, door trim must be removed before removing mirror adjustor.

3 - Door component carrier
4 - Socket head screw
- 12 Nm (9 ft.lb)
5 - Seal
- Check for correct fit during installation.







6 - Phillips head screw
- 1 Nm (9 in.lb)
7 - Mirror glass
- To remove, use special tool 80-200 (assembly lever).

- Use fabric reinforced adhesive tape at top and bottom to protect mirror housing from paint damage
- Pry mirror out at bottom first, then top.
- To install, first insert mirror lens into guide stud and friction finger in friction spring, then press on.

- Apply pressure only to center of lens; always wear protective gloves
8 - Friction finger
- Friction finger - 8 - must be pushed into friction spring - 9 - when inserting mirror glass in housing
9 - Friction spring