Splash Guard: Service and Repair

Noise Insulation Panel, Assembly Overview







1 - Quick-release screw
- Remove only this quick release screw for service position
- Three pieces
- 2 Nm (18 in.lb)
2 - Front noise insulation
3 - Quick release screw
- Three pieces
- If rear noise insulation panel is also - 4 - being installed, then longer quick-release screws must be used
- 2 Nm (18 in.lb)
4 - Rear noise insulation panel
- Only installed for certain engine types
- Installed over noise insulation panel - 2 -
5 - Quick-release screw
- Two pieces
- 2 Nm (18 in.lb)







6 - Mounting for noise insulation panel
- Position - 9 - must face left side of vehicle
7 - Bolt
- Two pieces
- 7.5 Nm (66 in.lb)
8 - Plate nut
- Two pieces
9 - Plate nut
- Three pieces
10 - Clamping pin
- Two pieces
11 - Wheelhousing liner
12 - Bumper
13 - Lock carrier with attachments