ABS Rear Axle Components, Removing and Installing

WARNING:
- Do not re-use any fasteners that are worn or deformed in normal use.
- Some fasteners are designed to be used only once' and are unreliable and may fail if used a second time. This includes, but is not limited to, nuts, bolts, washers/ circlips and cotter pins. Always replace these fasteners with new parts where indicated) and any other time it is deemed necessary on inspection.

1. ABS wheel speed sensor
- Identical part on left and right
- Removing and installing; Refer to Wheel speed sensor, Service and Repair.
- Release harness connector of ABS speed sensor cable and separate. Unclip speed sensor cable.

2. Clamping sleeve
- Always replace
- Identical part on left and right
- Grease all around with assembly paste before inserting into wheel bearing housing
- Press into wheel bearing housing until fully seated
3. Axle beam/rear axle with splash guard and stub axle
4. ABS wheel speed sensor rotor
- Removing and installing; Refer to Wheel speed sensor, Service and Repair.
5. Brake disc with wheel hub
6. Outer wheel bearing
7. Thrust washer
8. Hex nut
- Adjusting; Refer to Wheel speed sensor, Service and Repair.
9. Castellated lock
- Install onto hex nut
10. Grease cap
- Replace
11. Cotter pin
- Always replace