Oil Pump, Block Breather, Oil Jets, Removing and Installing

Oil pump, cylinder block breather and oil spray jets, removing and installing
Oil pan (upper part) and oil pan (lower part), removing and installing, Refer to Oil Pan, Engine, Service and Repair
1 - Bolt
^ 20 Nm (15 ft. lbs.)
2 - Washer
3 - Tensioner roller
^ For toothed belt
4 - Bolt
^ 45 Nm (33 ft. lbs.)
5 - Bolt
^ 10 Nm (7 ft. lbs.)
^ For toothed belt
6 - Bolt
^ 10 Nm (7 ft. lbs.)
7 - Bolt
^ 10 Nm (7 ft. lbs.)
8 - Breather housing
9 - Gasket/breather - plate
^ Always replace
10 - Oil check valve
^ 25 Nm (18 ft. lbs.)
11 - Oil seal
12 - Connector
13 - Bolt
^ 15 Nm (11 ft. lbs.)
14 - 15 Nm
^ For oil spray jets for piston cooling
15 - Cylinder block
16 - Bolt
^ 10 Nm (7 ft. lbs.)
^ Use locking fluid D 000 600 A2 when installing
17 - Oil spray jet
^ For piston cooling
18 - Gasket
^ Metal gasket
^ Always replace
19 - Engine oil - temperature sensor -G8
^ 10 Nm (7 ft. lbs.)
^ For oil temperature gauge
^ White
^ If seal is leaking, replace seal
20 - Oil seal
^ Replacing, Refer to Seals and Gaskets, Engine, Camshaft Oil Seal, Service and Repair
21 - Tensioner
^ Compress and secure before removing, Refer to Timing belt, Service and Repair.
22 - 10 Nm
^ Use locking fluid D 000 600 A2 when installing
23 - Washer
24 - Bearing bushing
^ For tensioner lever
25 - Washer
26 - Bolt
^ 25 Nm (18 ft. lbs.)
27 -Tensioning lever
28 - Bearing bushing
^ For tensioner roller