Three-Point Seat Belt With Seat Belt Height Adjuster
Three-Point Seat Belt With Seat Belt Height Adjuster and Belt Tensioner, Removing and Installing
1 - Seat belt height adjuster
Removing:
- Remove upper B-pillar trim.
- Remove shouldered nut -3- and bolt -2-.
- Remove seat belt height adjuster -1- up and out of position -A-.
Installing:
- Guide seat belt height adjuster switch -4- into height adjuster assembly -1-.
NOTE: Do not press switch -4- when installing.
Function check after installing trim:
- Height adjuster must audibly engage into all five of the possible positions (even in the top position).
- Switch must return by itself to upper position after being actuated.
2 - Bolt
- 23 Nm (17 ft lb)
3 - Shouldered-nut
- 50 Nm (37 ft lb)
4 - Switch for-height adjustment
5 - Belt guide
- Remove bolts -7- (2x).
- Unclip lower part of belt guide, swing upward and detach
6 - Bolts (2x)
- 2 Nm (18 in. lb)
7 - Bolt
- 50 Nm (37 ft lb)
8 - Bolt
- 50 Nm (37 ft lb)
9 - Belt tensioner
Removing three-point seat belt:
- Disconnect battery.
- Removing sill molding.
- Remove bolt -9- (1x).
- Remove upper B-pillar trim.
- Remove belt webbing from upper B-pillar trim.
- Remove lower B-pillar trim.
- Remove shouldered nuts -3-.
- Disconnect harness connector -C- at belt tensioner.
- Remove bolt -7-.
- Remove belt tensioner -9- upward out of anti-twist stop -11-.
Installing three-point seat belt:
NOTE: Arrow -B- indicates direction of travel.
- Install belt tensioner -9- with anti-twist stop -11- as shown in magnified area.
- Install belt webbing (turned 180°)as shown in illustration (arrow).
- Lower belt webbing must be bolted to metal stud -10- as shown in magnified area
- Remainder of installation is reverse of removal
- After installing passenger side three-point seat belt, check belt function for child seat.
- Three-point seat belt must not be hindered by cables, wires or dampening material etc..
10 - Metal stud in floor pan
- Anti-twist stop for belt webbing bracket
11 - Anti-twist stop and reverse-mounting protection for three-point safety belt
Fig. 1 Installing upper 6-pillar trim in belt height adjuster
- Guide slide with button -4- (without pressing) beginning at top and working downward into release lever -1- of height adjuster while simultaneously installing pin -2- into mounting -3-.