Assembling Gear Lock

Assembling gear lock






- Insert spring -1- into housing -2- and, while applying light pressure, turn spring to left until it locates in base of housing.
- Insert bushing -3- onto spring so bent end of spring locates into groove properly.
- Push bushing against spring and turn approximately one turn to left, until lug on bushing aligns with groove in housing.
- Press lug of bushing into groove in housing onto stop.
- Turn bushing to right and release.
- The bushing will spring into the correct position.






Installation position of bushing:

- Lug (arrow -A-) of bushing must always face away from groove in housing (arrow -B-).
- Checking installation position:
- Turn bushing to left and release.
- The bushing should spring back into position; the lug must be against the stop (direction indicated by arrow -A-).






Installation position of complete gear lock in transmission:

- The recess (arrow -A-) faces bolt (arrow -B-).