Side Padding For Rear Seat, Removing and Installing

Side Padding For Rear Seat, Removing And Installing







1 - Side padding

Removing
- Remove rear seat bench.
- Remove bolt - 1 - (1x).
- Bolts - 2 - are only installed on vehicles with side airbag
- On vehicles with side airbags: disconnect connector Fig. 1.
- Loosen nut - 3 -.
- Remove striker pin - 4 - together with washer - 5 - and dished washer - 6 -.
- Pull side padding - 1 - out of bottom retainer - 7 -.







Installing
- Press side padding - 1 - into bottom retainer - 7 -.
- Adjust striker pin - 4 - and tighten nut - 3 -.

2 - Screw (1x)
- Tightening torque: 8 Nm (71 in.lb)
3 - Nut
- Tightening torque: 50 Nm (37 ft lb)
4 - Striker pin
5 - Washer
6 - Dished washer
7 - Retainer







Fig. 1 Disconnecting side airbag connector
- Press in retainer tab - 2 - and pull out connector - 1 - in direction of arrow.