Speedometer Sender and Drive Wheel, Removing and Installing

Transmission installed
- Observe general repair instructions.

Speedometer sender -G22-, removing and installing
Removing





- Pull connector off sender -A-.
- Press retaining clip down, turn sender sideways and pull out upward.

Installing
- When installing replace seal -B-.
- Insert sender and engage.
- Handle sender carefully. If damaged it is possible that the speedometer will not indicate exactly.

Speedometer drive wheel, removing and installing
^ Drift VW195
^ Drift VW 295
^ Extractor lever VW 681
^ Drip tray V.A.G 1306

Removing
- Remove drive flange on left side.
- Remove speedometer sender.





- Press retaining clips in direction of arrows with a screwdriver.
- Remove drive wheel by levering out, alternating between sides.

Installing
Installation is carried out in the reverse order, when doing this note the following:

Note: Fit the drive wheel carefully onto the differential, making sure that it is kept straight. Do not use force; the drive wheel can break easily.

Installation position:





- The drive peg of the drive wheel -A- faces to seal -B- and locates in the groove of the differential.
The retaining clips (arrows) locate in the circumferential groove in differential.
- Always replace seal -B- and circlip -C-.
- Knock drive flange in with drift VW 295.
- Top up oil in transmission and check oil level.





Tightening torques