Input Shaft Ball Bearing and Multi-Function Sender

1. Transmission housing
^ With differential and drive flanges
^ Removing and installing differential and drive flanges
^ Removing and installing speedometer sender and drive wheel
^ Breather installation position see Fig. 1
2. Torx socket head bolt, 35 Nm
^ Self-locking
^ Replace
3. Guide sleeve
^ With O-ring and oil seal for input shaft
4. Dished washer
^ Smaller diameter (convex side) faces guide sleeve
5. Circlip
^ Determining thickness adjusting input shaft
6. Bearing
^ Removing and installing
7. Circlip
^ Determining thickness adjusting input shaft
8. Input shaft
^ Removing and installing
^ Disassembling and assembling
^ Servicing input shaft bearings
9. Bolt, 25 Nm
10. Locking plate
^ For multifunction sender
11. Multi-function sender
12. Multi-function sender connector
13. Bolt, 10 Nm
14. Cover for selector shaft
^ Removing and installing
15. Locking unit for 5th gear and reverse gear
^ Removing and installing





Fig. 1 Breather installation position
After pressing in, the breather must project 21 mm out of housing.