Switches In Center Console, Removing and Installing

Removing:







- Insert fabricated tools -C- (See below) in opening -D- and pull vent evenly from instrument panel insert.


NOTE: Do not hook fabricated tools -C- in vent vanes as the vent can break.







- With your hand reach through the opening and from behind and press out applicable switch.
- Pull out switch further and disconnect electrical connector.

Installing:
- Install electrical connector.
- Insert switch into opening and press in until catches engage
- Install air vents in instrument panel and engage catches.

Tool for removal of air vent







- Fabricate tool from wire approximately 3mm dia. (0.120 in.) as shown.
Dimension x = 6 mm (0.24 in.)