Right Cylinder Head Cover, Removing and Installing

Removing





- Remove engine cover panel -arrows-.
- Remove cover -2-.





- Remove air intake duct -arrows- between air cleaner and throttle valve unit.





- Disconnect fuel supply and fuel return lines -1-.
- Disconnect hose -2-.





- Disconnect connectors -1- from ignition coils.
- Remove bracket -2-.
- Remove ignition coils -3-.
- Disconnect crankcase breather hose.
- Remove cylinder head cover.

Installing
Install cylinder head in reverse order of removal but note the following:

Note: Replace cylinder head cover gaskets if damaged.





- Apply a small amount of sealant D 545 300 A2 to sealing points -arrows- on sealing surface of cylinder head.

CAUTION! Part numbers are shown here for reference only. Always check with your Parts department for latest information.





- Tighten cylinder cover according to number sequence in illustration.

Tightening Torques (Part 6 Of 18):

Tightening Torques