Rear Occupied Seat Sensor, Removing and Installing

Rear Occupied Seat Sensor, Removing And Installing

Removing

- Remove rear seat bench.







- Cut through tie wrap for wiring 2-pin connector -2- (left and right) and disconnect from grille frame.

1 - Seat cover
3 - Connector for seat heater
4 - Connector for rear seatback







- Remove cover -2- for rear seat left and right.
- Separate sensor mat -3- from cushion -1- carefully at locations identified with arrows.
- Remove electrical wiring from opening -4-.

Installing
Installation is done in reverse sequence, noting the following:


CAUTION!
Sensor mat must not be creased, otherwise mat will malfunction.







- Position sensor mat -3- without folds or bends at adhesive location (arrows) on cushion -1-.
- Install electrical wiring in opening -4-.
- Slide sensor mat at -5- in folds.


NOTE: When installing cover -2- for rear seat bench, be careful that the sensor mat at -5- are not damaged.


- After installation, check function of sensor mat.