Trunk / Liftgate Shock / Support: Service and Repair

Removing And Installing Gas-filled Strut







Removing
- Using screwdriver, push back retaining springs slightly at both ends of gas-filled strut and unclip gas-filled strut.

NOTE: When removing or installing the gas-filled strut, push back the opened rear lid slightly without damaging the components.

Installing
- Clip in gas-filled strut at bottom first, then at top. Install with tube end of strut at rear lid

Releasing gas from strut







- Clamp gas-filled strut in vice in area - x -.
Dimension -x- = 50 mm (2 in.)
- Using saw, cut into cylindrical part of strut at point within first third of cylinder's length (measured from piston rod end of cylinder).

WARNING: The gas-filled strut must only be clamped in the vice at the area indicated; otherwise there is a risk of accident.

NOTE: Always wear eye protection when performing this procedure. Cover the sawing area with a clean rag to contain any escaping fluid.